| –
| Cut the nozzle of the tube at the front mark (nozzle diameter: approx. 3 mm). |
| –
| Apply the silicone-based sealant to the clean contact surface of the oil sump, as shown in the illustration. The bead should: |
| pass by the inner edge of the boltholes -arrows-. |
Note! | The sealant bead must not be thicker; otherwise excess sealant may get into the oil sump and obstruct the oil intake line filter. |
| –
| Fit the oil sump immediately and tighten all the mounting bolts slightly. |
| –
| Tighten the oil sump mounting bolts to a torque of 15 Nm. |
Note! | After the installation of the oil sump, let the sealant dry during approx. 30 minutes, after which oil may be added. |
|
|
|
