seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Toothed belt: removing and installing, tightening > < Poly-V belt: Removing and installing

Leon Mk2

Distribution timing: testing
Distribution timing: testing
–  Remove the upper toothed belt shield.
   
–  Position the crankshaft at top dead centre cylinder 1. The mark on the pulley should coincide with the mark -O-.
  N13-0451
–  The lock holes in the camshaft pinions should coincide with the holes in the camshaft housing -arrows-.
–  Introduce lock pins -T10016- in the lock holes of the camshaft pinions and in the holes in the camshaft housing.
  Note!
If the marks are on the opposite side from the pinions, turn the crankshaft over once.
  N13-0155

Toothed belt: removing and installing, tightening > < Poly-V belt: Removing and installing