seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Engine support rubber bearings: replacing

Leon Mk2

Work sequence
Work sequence
   
–  Fit crossmember -U-30025B-, secure in the ring to the left of the cylinder head and slightly pretension the engine.
–  Remove the fastening from the front engine unit support.
–  Remove the engine unit crossmember from the vehicle.
  E10-0029
–  Lever to separate the washers from the spacers (replace the damaged and/or bent washers).
–  Pull the spacer bushings out and remove the rubber bearings.
–  Fit the new rubber bearings and insert the spacer bushings.
–  Go lightly over the edges of the spacer bushing until the washers can be fitted.
  V10-1337
–  Fit the rubber bearing (dipped in soapy water) in bushing -U-40501-, position the tools on the engine unit crossmember as shown in the figure (bear in mind that the conical part of expansion nut -T20090- must not touch the bushing).
Turn nut -T20090- until the rubber bearing is seated in its position.
  E10-0034
–  Position the washers -1- and fit nut -T20090- (with the conical part in the direction of the washer), turn the nut until the edge of the spacer bushings expands.
  E10-0035

Enginecrankshaft group, pistons > < Engine support rubber bearings: replacing