BaCooling system components: removing and fitting |
Note! t
| The cooling system is under pressure when the engine is hot. Thus pressure must be reduced before repairing. |
t
| The hoses connections are secured with strip clamps. In the event of repair, use only strip clamps. |
t
| Pliers -T20029- are recommended for fitting strip clamps. |
t
| The coolant hoses should be fitted without stresses and without touching other components (check the indicating mark on the coolant connection and on the hose). |
Test the cooling system for leakage with the -V.A.G 1274- or -SAT 1274- and the adaptor -V.A.G 1274/3-. |
Cooling system components, bodywork → Chapter. |
Instructions on coolant mix → Chapter;Coolant: draining and filling. |
|
|
|