Leon Mk2
Note
|
| 1 - | Engine block |
| q | Aluminium cylinder block - Components overview → Chapter |
| q | Piston and conrod - Components overview → Chapter |
| 2 - | 50 Nm |
| q | Tightening order: First tighten the upper right-hand bolt, then the lower right-hand one and finally the left-hand bolts (viewed in direction of travel) |
| 3 - | Oil filter |
| q | Loosen at the hexagonal, using the universal oil filter wrench or the rotation tool -U-40078- |
| q | Tighten the filter by hand |
| q | Observe the installation instructions printed on the filter |
| 4 - | M8: 20 Nm + 1/4 turn (90º) |
| 5 - | Compact bracket |
| q | For alternator, heating compressor and Poly-V belt tensioner |
| q | Removing and installing compact bracket in vehicles fitted with air conditioning /heating → Heating, air conditioning/heating; Rep. Gr.87 |
| 6 - | 13 Nm |
| Loosen and tighten the bolts on the side of the flywheel using the spanner -U-40051A- |
| 7 - | Oil sump |
| q | Removing and installing → Chapter |
| q | Fit with a silicon based sealant D 176 404 A2 → ETKA (electronic parts catalogue) |
| q | Clean sealing surface before installing |
| 8 - | Oil purge bolt, 30 Nm |
| q | In engines where the bolt and ring form a single piece, replace the unit. |
| 9 - | Tensioning element |
| q | For Poly-V belt |
| q | Only for vehicles fitted with air conditioning (heating) |
| q | To reduce tension in the Poly-V belt, use a wrench on the tension roller securing bolt. |
| q | Poly-V Ribbed belt: removing and installing → Chapter |
|
|
