seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Radiator fanV7 and fan 2 of the radiatorV177: Removing and installing. > < Removing and installing radiator fan control unitJ293

Leon Mk2

Removing and installing radiator cowl
Removing and installing radiator cowl
t  Removing → Anchor
t  Fitting → Anchor
   
Removing
–  Remove engine cover panel -arrows-.
–  Remove front bumper cover → Rep. gr.63.
–  Move lock carrier to service position → Rep. gr.50.
  E10-10127
–  Detach the electrical connectors -1- and -2- from the bracket and unplug them.
–  Move electrical wiring clear.
  A10-10282
–  Separate the plug connections -1- at the turbocharger pressure sensor and place the cables to one side.
–  Unscrew bolts -arrows- and lift out radiator cowl.
Installing
Reassembly is carried out in the reverse order; note the following:
–  Install the lock carrier with attachments → Rep. gr.50.
  A19-10153
–  The torque reaction support must set itself on its rubber stop by means of its self weight, then tighten the nuts -arrows-.
–  Install bumper cover (front) → Rep. gr.63.
l  Tightening torque → Chapter „Radiator and radiator fan: Assembly overview“
  A10-10288

Radiator fanV7 and fan 2 of the radiatorV177: Removing and installing. > < Removing and installing radiator fan control unitJ293