Leon Mk2
| Crankshaft - exploded view |
| 1 - | Half bearings 1 and 4 |
| q | For bearing cap without oil groove. |
| q | For cylinder block with oil groove. |
| q | Do not interchange used bearing shells (mark). |
| 2 - | 65 Nm + 90° (1/4 turn) further |
| q | 10 off |
| q | Replace |
| q | For the measure of radial play, tighten to 65 Nm but not more |
| 3 - | Bearing cap |
| q | Bearing cap 1: Pulley side: |
| q | Bearing cap 3 with rebates for the thrust washer |
| q | Bearing shell retaining lugs in cylinder block and bearing caps must align. |
| 4 - | Bearing cap |
| q | For bearing cap without oil groove. |
| q | For cylinder block with oil groove. |
| 5 - | Thrust washer |
| q | For bearing cap 3. |
| q | Note fixing arrangement. |
| 6 - | Crankshaft |
| q | New axial play: 0,07 ... 0.17 mm Wear limit: 0.37 mm |
| q | Recheck the radial play using a Plastigage New: 0,03 ... 0.08 mm Wear limit: 0.17 mm |
| q | Do not rotate the crankshaft when checking the radial clearance |
| q | Crankshaft dimensions → Chapter |
| 7 - | Thrust washer |
| q | For cylinder block, bearing 3 |
