SEAT Workshop Service and Repair Manuals

Engine and direct shift gearbox: Separate Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  counterhold -T20186-, see equivalent → Anchor

t  Workshop crane -VAS 6100-, see equivalent → Anchor

Operation process l  Engine/gearbox assembly removed and attached to engine bracket -T10012-. –  Remove coolant hoses from gearbox oil cooler, loosen hose clips -arrows- for this.

–  Place the support tool -T20186- on the gearbox, as shown in the illustration. –  Hang the workshop crane -VAS 6100- using the support tool -T20186-.   WARNING When transporting, take care not to damage the transmission oil radiator.

–  Free wiring harnesses -arrows- and electrical connector -1- at bracket.

–  Unscrew bolts -1- and -2- and remove starter from gearbox.   Note This is shown in the figure with the gearbox removed.

–  Unscrew remaining bolts -1, 3, 5, 6, 7, 8, 9, 10- from gearbox to engine connection.   Note t  Bolt -3- is only accessible after removing starter. t  Disregard: -Items 2, 4-and-A- –  Separate gearbox from engine.