SEAT Workshop Service and Repair Manuals

Right coolant pipe: Removing and installing t  Removing → Anchor. t  Fitting → Anchor. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Hose clamps -3094-, see equivalent → Anchor

t	Collecting tray -VAS 6208-, see equivalent → Anchor

t	Base -VAS 6499-, see equivalent → Anchor

Removing . –  Remove the engine cover upwards -arrows-.

–  Slacken bolt -1- and unscrew bolt -2- and nut -3-. –  Take hose retainer -4- off fuel filter, place fuel filter -7- aside (fuel hoses -5- and -6- remain connected).

–  Remove centre noise insulation -fastening points 1 ... 3-.

–  Remove right noise insulation -fastening points 1 ... 3-.

–  Place drip tray for workshop hoist -VAS 6208- beneath engine. –  Remove connector -3- on the coolant temperature sender -G83- at the radiator outlet. –  Disconnect and remove the coolant hoses with the hose clip -3094-.

–  Release hose clips -arrows- and pull coolant hoses off right coolant pipe. –  Unscrew nut -1- and bolt -2-, and remove right coolant pipe. Fitting . l  Tightening torques → Chapter Installation is carried out in reverse order, noting the following:   Note Secure all hose connections with the hose clips corresponding to original equipment → Electronic parts catalogue. –  Fill up coolant → Chapter.