Leon Mk2
| Sump, oil pump: Assembly overview |
| 1 - | 15 Nm |
| 2 - | Sealing flange |
| q | With seal |
| q | Must be assembled on dowel sleeves |
| q | Removing and installing → Chapter |
| q | Fit with Silicon sealant -D 176 404 A2- |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Replace crankshaft oil seal - pulley side → Chapter. |
| 3 - | Toothed belt for oil pump |
| q | Check for damage and wear. |
| q | Renew if necessary. |
Note| t | Belts which have been in use longer can sag. |
| t | This is not a fault and does not necessarily mean belt needs replacing. |
| 4 - | 10 Nm |
| 5 - | Oil dipstick |
| q | Oil level must not be above max. mark on dipstick! |
| q | Markings → Chapter. |
| 6 - | Guide tube |
| 7 - | Clip |
| 8 - | Dowel sleeves |
| q | Renewing |
| 9 - | O ring |
| q | Renewing |
| 10 - | 10 Nm |
| 11 - | Oil pump with gear wheel mounted under pressure |
| q | With 12 bar pressure relief valve |
| q | Before installing, check that both dowel sleeves for centring oil pump on cylinder block are fitted. |
| If toothed belt or oil pump have to be removed: |
| t | Check oil pump for free movement |
| t | The gear wheel must rotate easily when it is turned using one finger. |
| t | Replace if binding. |
| 12 - | Oil intake pipe |
| q | Clean strainer if soiled. |
| 13 - | Oil settling tank |
| 14 - | 15 Nm |
| 15 - | Bolt |
| q | Specified torques and installation sequence → Fig.. |
| 16 - | Oil sump |
| q | Clean sealing surface before fitting. |
| q | Install with silicone sealant -D176404A2-. |
| q | Removing and installing → Chapter |
| 17 - | 15 Nm |
| 18 - | Oil seal |
| q | Renewing |
| 19 - | Oil drain plug, 30 Nm |
| q | Renewing |
| 20 - | 10 Nm |
| 21 - | Oil level and oil temperature sender -G266- |
| q | Black connecting plug, 3-pin |
| q | Removing and installing → Chapter |
| 22 - | Oil seal |
| q | Renewing |
| 23 - | Wiring harness of the oil level and oil temperature sender |
| 24 - | 27 Nm |
| q | Place without coolant |
| 25 - | Oil spray jet |
Note
|
|