Leon Mk2
| Assembly overview - poly V-belt drive |
| 1 - | Poly V-belt |
| q | Check for wear. |
| q | Before removing, mark direction of rotation with chalk or felt-tipped marker pen. |
| q | Removing and installing → Chapter. |
| q | Do not kink. |
| q | When installing, make sure it is properly seated on poly V-belt pulleys. |
| 2 - | Tensioning roller for poly V-belt |
| q | Removing and installing → Chapter. |
| q | Coat guide surfaces with lubricating paste; lubricating paste → Electronic parts catalogue. |
| 3 - | Vibration damper |
| q | With poly V-belt pulley. |
| q | Assembly through offset holes only possible in one position. |
| q | Fitting position: Hole in vibration damper must be positioned above the raised section of the crankshaft sprocket |
| 4 - | 10 Nm + 90° |
| q | Renew |
| q | Use only genuine bolts → Parts Catalogue. |
| 5 - | Dowel sleeve |
| q | Check for correct seating in ancillary bracket. |
| 6 - | 20 Nm + 90° |
| 7 - | 50 Nm + 90° |
| 8 - | Guide roller |
| q | For toothed belt |
| 9 - | 15 Nm |
| 10 - | Guide roller |
| q | For toothed belt |
| 11 - | Bracket for ancillaries |
| q | Removing and installing → Chapter. |
| 12 - | High-pressure pump |
| q | Removing and installing. |
| 13 - | Bolt |
| q | Specified torques and installation sequence → Fig.. |
| 14 - | Alternator |
| q | Removing and installing → Rep. gr.27. |
| 15 - | 20 Nm |
| 16 - | Air conditioner compressor |
| q | Removing and installing → Rep. gr.87. |
| 17 - | 45 Nm |
| 18 - | Dowel sleeve |
| q | Check for correct seating in ancillary bracket. |
| 19 - | Bolt |
| q | Specified torques and installation sequence → Fig.. |
Note
|
|
| Stage | Bolt | Specified torque/turning further angle | ||
| 1. | -Arrow- | Screw in to contact by hand.
| ||
| 2. | -Arrow- | Turn until tensioning roller bolt reaches stop
| ||
| 3. | -Arrow- | Turn back 90° | ||
| 4. | -Arrow- | 30 Nm | ||
| 5. | -Arrow- | Turn 90° further |
