Leon Mk2
| cylinder block: Assembly overview |
| 1 - | cylinder block |
| q | Removing and installing sealing flange and flywheel → Chapter. |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 2 - | Gasket |
| q | Renewing |
| 3 - | Oil filter bracket |
| 4 - | 15 Nm + turn 90° further |
| q | Renewing |
| q | First fit upper left and lower right bolts and then tighten all four bolts diagonally. |
| 5 - | Retainer |
| 6 - | 10 Nm |
| 7 - | Joint mouth |
| q | For thermostat. |
| 8 - | 15 Nm |
| 9 - | O ring |
| q | Renewing |
| 10 - | Coolant thermostat: |
| q | Observe installation position, Removing and installing thermostat → Chapter. |
| q | Check: heat the thermostat in water |
| q | Opening begins at approx. 85 °C. |
| q | Ends at approx. 105 °C. |
| q | Opening lift at least 7 mm. |
| 11 - | 20 Nm + turn 180° further |
| 12 - | Retainer |
| q | For ancillaries |
| q | Removing and installing → Chapter |
| 13 - | 40 Nm + turn 45° further |
| q | Renewing |
| 14 - | Poly V-belt tensioning element |
| 15 - | Oil sump |
| q | Clean sealing surface before fitting. |
| q | Install with silicone sealant -D 176 404 A2-. |
| 16 - | 15 Nm |
