Leon Mk2
| Poly-V belt with air conditioner compressor: Assembly overview |
| 1 - | Poly-V belt |
| q | Mark direction of rotation with chalk or felt pen before removing |
| q | Check for wear. |
| q | Do not kink. |
| q | Removing and installing → Chapter |
| q | Distance → Fig. |
| q | When installing, make sure it is properly seated on the pulleys. |
| 2 - | Special bolt -10 Nm + 90° (1/4 turn) |
| q | Renewing |
| q | Use only genuine bolts → Spare parts catalogue |
| 3 - | Vibration damper |
| q | For ribbed belt pulley |
| q | Installation position: Hole in vibration damper must be positioned above the raised section of the crankshaft gear wheel |
| q | Removing and installing → Chapter |
| 4 - | Poly V-belt tensioning element |
| q | Removing and installing → Chapter |
| 5 - | Dowel sleeves |
| q | Check for correct seating in ancillary bracket. |
| 6 - | 25 Nm |
| 7 - | Bracket for ancillary mechanical units |
| q | Removing and installing → Chapter |
| 8 - | 23 Nm |
| 9 - | Bolt |
| q | Specified torque and tightening sequence → Anchor. |
| 10 - | Alternator |
| q | Removing and installing → Rep. gr.27 |
| 11 - | 25 Nm |
| 12 - | Air conditioning compressor |
| q | Removing and installing → Rep. gr.87 |
| 13 - | 45 Nm |
| 14 - | Bush |
| q | Make sure it fits well in the support |
|
|
