seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Cooling system components, engine side - Assembly overview > < Removing and installing coolant pump

Leon Mk2

Removing and installing coolant circulation pumpV50
Removing and installing coolant circulation pump -V50-
Coolant circulation pump -V50-: Removing → Anchor
Coolant circulation pump -V50-: Fitting → Anchor
   
Special tools and workshop equipment required
t  Measuring tool -T10007-, see equivalent → Anchor
t  Base -T20174-, see equivalent → Anchor
t  Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent → Anchor

   
t  Hose clips -3094-
  W00-0079
Removing
–  Disconnect connector -3- and remove the coolant pipes -arrows-.
–  Unscrew the fastening bolt -2- and remove the coolant pump -V50-.
–  Clamp off coolant hoses with hose clamps -3094- and disconnect hoses from coolant circulation pump -V50-.
  Note
Ignore positions -1- and the -arrows-.
Installing
Install in reverse order to dismantling, noting the following:
l  Tightening torques → Chapter
–  Check coolant level → Anchor.
  A19-10620

Cooling system components, engine side - Assembly overview > < Removing and installing coolant pump