seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Renewing crankshaft oil seal - pulley end > < Assembly overview

Leon Mk2

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28 -
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Socket and key -T10370-
  W00-10582
t  Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent → Anchor
Engine speed sender -G28 -: Removing → Anchor
Engine speed sender -G28 -: Fitting → Anchor
  W00-0427
Removing
–  Separate the connector -1- of the engine speed sender -G28 -.
–  Remove the gasket -2- from the engine block and remove the engine speed sender -G28- using the socket -T10370 -.
Installing
Install in reverse order to dismantling, noting the following:
–  Fit the engine speed sender -G28- and tighten the attachment bolt to 5 Nm.
  N13-10291

Renewing crankshaft oil seal - pulley end > < Assembly overview