Leon Mk2
| Part I Intake manifold |
| 1 - | Coupling hose |
| 2 - | Fuel line |
| q | High pressure |
| Tightening torques of connection nuts |
| To the high-pressure pump: 18 Nm |
| to the intake manifold lower part: 20 Nm |
| 3 - | Bolt |
| q | Tightening torque: 8 Nm |
| 4 - | Clip |
| 5 - | Fuel hose |
| q | Low pressure |
| q | To high pressure pump |
| 6 - | Spring-type hose clip |
| q | Removing and installing with the pliers -T20174- |
| 7 - | Joint mouth |
| q | For the fuel supply |
| 8 - | Retaining valve |
| q | For engine block ventilation pre-heater |
| 9 - | Bolt |
| q | Tightening torque: 8 Nm |
| 10 - | O ring |
| q | replace |
| 11 - | Joint mouth |
| q | To distribution casing |
| 12 - | Impulse line |
| q | From turbocharger |
| 13 - | Coupling hose |
| q | To camshaft housing |
| 14 - | Retaining valve |
| 15 - | Coupling hose |
| q | To air filter housing |
| 16 - | Coupling hose |
| q | to active carbon reservoir |
| 17 - | Activated charcoal filter solenoid valve 1 -N80- |
| 18 - | Coupling hose |
| 19 - | Clip |
| 20 - | Coupling hose |
| 21 - | Coupling hose |
| q | To turbocharger |
