Leon Mk2
| Fuel supply unit and fuel level indicator sender: Assembly overview |
| 1 - | Fuel gauge senders -G- |
| q | Checking resistance values → Chapter |
| q | Removing and installing → Chapter |
| 2 - | Fuel delivery unit |
| q | Checking fuel pump (electrical test) → Chapter |
| q | Removing and installing → Chapter |
| q | Put at least 5 litres of fuel into tank after installing |
| 3 - | Seal |
| q | replace |
| q | Install dry |
| 4 - | Fuel return line |
| q | Mark before removing |
| q | Press release tab on pipe connector to disconnect |
| q | Do not kink |
| q | Note direction of arrow (fuel supply or fuel return system) on flange when installing |
| q | Install on fuel tank |
| 5 - | Fuel supply line |
| q | Mark before removing |
| q | Press release tab on pipe connector to disconnect |
| q | Do not kink |
| q | Note direction of arrow (fuel supply or fuel return system) on flange when installing |
| q | Install on fuel tank |
| 6 - | Connector |
| q | For fuel gauge sender -G- |
| q | For fuel system pressurisation pump -G6- |
| 7 - | Union nut: 80 Nm |
| q | Remove and install with the Connection nut wrench -3217-, see equivalent → Anchor |
| 8 - | Impulse line |
| q | Press release tab on pipe connector to disconnect |
| 9 - | Spray jet: |
