Leon Mk2
Fuel tank with accessory parts: Assembly overview |
Note
The fig. shows a fuel system without return line. |
1 - | Fuel line |
q | From fuel filter. |
q | To engine. |
q | Do not kink |
q | To disengage, press the clip in the joint to unlock it |
2 - | Fuel return line |
q | From filter, with check valve |
q | Do not kink |
q | Press release tab on pipe connector to disconnect |
q | Install on fuel tank |
3 - | Breather line |
q | For the active carbon filter system in front right wheel housing |
q | Do not kink |
q | To disengage, press the clip in the joint to unlock it |
q | Install on fuel tank |
4 - | 2 Nm |
5 - | Heat shield |
q | For fuel filler neck |
6 - | 23 Nm |
q | Secures fuel filler neck and earth connection → Item |
7 - | Overflow hose |
q | Engage in wheel housing |
8 - | Rubber bearing |
9 - | Tensioning ring |
10 - | Seal |
q | If this is damaged, replace it |
11 - | Sealing cap |
q | Fitted on tank flap unit with a securing device |
12 - | Earth connection |
q | To divert electrostatic charge |
q | Installation position / Testing standard → Fig. |
q | Ensure correct fitting of the connector and securely tighten the line with the securing bolt for the fuel filler neck → Item |
q | After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body: Approx. 0 Ω |
13 - | Breather line |
14 - | Fuel tank |
q | Removing and installing → Chapter |
15 - | Heat shield |
q | For fuel tank. |
16 - | 2 Nm |
17 - | Heat shield |
q | For fuel tank. |
18 - | 2 Nm |
19 - | Spreader clip |
20 - | Retaining strap |
q | Note different lengths |
21 - | 23 Nm |