seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Turbocharger - exploded view > < Removing and installing accelerator pedal module with accelerator position sender

Leon Mk2

Turbocharger
Turbocharger
→ Chapter „Turbocharger - exploded view“
→ Chapter „Fitting air pipes/hoses with plug-in connectors“
→ Chapter „Removing and installing turbocharger“
→ Chapter „Checking vacuum unit for turbocharger“
→ Chapter „Removing and installing vacuum unit for turbocharger“
→ Chapter „Adjusting vacuum unit for turbocharger“
  Note
t  Secure all hose connections with hose clips which conform to production standard.
t  The brackets for the hoses and the supercharger air system tubes must be free from oil and grease for fitting. However (applies only to plug-in connectors); the seal and the sealing surface of plug-in connectors should be lubricated lightly with oil → Chapter.
t  Charge air system must be free of leaks.
t  Renew self-locking nuts.
t  Spring-type clip pliers -VAS 6499- or hose clip pliers -VAS 6340- are recommended for installation of spring-type clips.
t  Fill turbocharger with engine oil at oil supply line connection.
t  After installing turbocharger, allow engine to idle for approx. 1 minute and do not rev up immediately to ensure turbocharger is supplied with oil.
t  Observe rules for cleanliness → Chapter.
   

Turbocharger - exploded view > < Removing and installing accelerator pedal module with accelerator position sender