| 1 - | Lambda probe, after catalytic converter -G130- and Lambda probe heater 1, after catalytic converter -Z29- |
| 2 - | Lambda probe -G39- and Lambda probe heater -Z19- |
| l
| Tightening torque: 55 Nm |
Note | t
| New Lambda probes are coated with an assembly paste. This paste must not get into the slots on the probe body. |
| t
| In the case of a used Lambda probe grease only the thread with high-temperature paste. This paste must not get into the slots on the probe body. Locking fluid for hot working bolts → Parts catalogue |
| t
| When re-installing the electric wire of the Lambda probe,, it is important that these are connected to the same locations. Contact of the electric wires with the exhaust pipe must be prevented in all cases. |
| Removing and installing Lambda probe -G39- and Lambda probe heater -Z19- → Chapter. |
| Lambda probe after catalytic converter -G130- and Heater for lambda probe 1, after the catalytic converter -Z29-: Removing and installing → Chapter. |
|
|
|
