Caution Crankshaft is not to be removed. Just loosening the main bearing caps will cause deformation of the crankshaft bearings. This deformation reduces the bearing clearance. Even if the half-bearings are not replaced, changes in the bearing clearance may cause damage. |
If the bearing cap bolts are loosened, the cylinder block must be replaced complete with the crankshaft. |
Crankshaft bearing clearance cannot be measured using workshop equipment. |
|
Renewing crankshaft oil seal on pulley end → Chapter |
Tightening procedure of the Poly-V belt sprocket bolts → Chapter |
Note Note the distinctive characteristics of the sealing flanges for the crankshaft -flywheel side- and the installation equipment -T10017- y -T10134- → Chapter |
Replace the sealing flange for the crankshaft, flywheel side (vehicles with manual gearbox) → Chapter |
Replace the sealing flange for the crankshaft, flywheel side (vehicles with automatic gearbox) → Chapter |
|
|
|