SEAT Workshop Service and Repair Manuals

Removing and installing camshaft removing → Anchor Fitting → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Drip tray -VAS 6208-

t  Pliers for spring-type clips -VAS 6499- or Pliers -T20174-, see equivalent → Anchor removing –  Remove engine cover → Chapter.

Vehicles with engine code BWA –  Loosen the bolts and clamps -arrows-, and remove the supercharger air pipe with the hose facing downwards.

Vehicles with engine code BWJ –  Pull out the plug -3-. –  Separate the clamp -1- and remove the hose. –  Remove bolt -2-.

–  Pull out the plug -2-. –  Loosen the clamp -1-. –  Loosen the bolts -arrows-, and remove the supercharger air pipe with the hose facing downwards. Continued for all vehicles –  Drain coolant → Anchor

–  Loosen the connectors -arrows-.

–  Release the coolant hoses from the coolant pipes -arrows-.

–  Release the hose -A-, and loosen the bolt -B-. Remove the front coolant hose.

–  Loosen the connectors -A- from the support, release the hose -B-, and loosen the bolts -C-. Remove the rear coolant hose. Fitting Installation is performed in the reverse sequence.