SEAT Workshop Service and Repair Manuals

Oil radiator: removing and installing Removing → Anchor Fitting → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Tray -VAS 6208-, see equivalent → Anchor

t  Pliers for spring-type clips -VAS 6499- or Pliers -T20174-, see equivalent → Anchor Removing   WARNING Hot vapour/hot coolant may escape when opening expansion tank. Cover cap with cloth and open carefully. –  Open the cap of the coolant expansion tank. –  Remove engine cover → Chapter. –  Remove the central soundproofing pan → Bodywork, exterior fitting work; Rep. Gr.50. –  Drain coolant → Chapter –  Remove intake manifold → Chapter.

–  Remove the mount for the cable connector -arrows- on the coolant hose.

–  Remove coolant hose -1-. –  Remove bolt -2-.

–  Remove coolant hoses -arrows-. –  Unscrew bolt -1- and remove the coolant hose.

–  Unscrew bolts -A- and -B- from the oil radiator. –  Remove the oil radiator. Fitting Installation is carried out in the reverse sequence; note the following:   Note t  Replace gaskets and seals. t  Secure all hose connections with hose clamps as shown in the series production → parts catalog. –  Fill up coolant → Chapter.