Leon Mk2
| Sealing flanges: assembly overview |
| 1 - | 90 Nm + 1/4 turn. (90°) |
| 2 - | Crankshaft sprocket |
| 3 - | 15 Nm |
| 4 - | Oil seal |
| q | Do not grease or oil the seal lip of the seal |
| q | replacement → Chapter |
| 5 - | Sealing flange (pulley side) |
| q | Must sit on dowel pins |
| q | Removing and fitting → Chapter |
| q | For removing and installing, detach the oil sump |
| 6 - | cylinder block |
| q | Remove and fit the oil pump with rotational balancing unit → Chapter |
| q | Crankshaft: removing and fitting → Chapter |
| q | Dismantle and assemble pistons and conrods → Chapter |
| 7 - | 60 Nm + 1/4 turn. (90°) |
| q | Replace. |
| 8 - | Flywheel |
| q | To remove and fit the engine flywheel, immobilise it with the retention tool -3067- |
| 9 - | Intermediate plate |
| q | Must sit on dowel sleeves |
| q | Do not damage/bend when assembling |
| 10 - | Sealing flange with sealing ring |
| q | Always replace completely |
| q | Removing and fitting → Chapter |
| 11 - | Diamond-coated washer |
| q | Replace. |
