seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Supercharger air system tightness (engine codes BWJ, CDLA, CDLD) > < General diagram of the exhaust gas turbocharger supercharger air system (engine codes BWJ, CDLA, CDLD)

Leon Mk2

Removing and installing the charge air cooler (engine codes BWJ, CDLA, CDLD)
Removing and installing the charge air cooler (engine codes BWJ, CDLA, CDLD)
t  Removing → Anchor
t  Installing → Anchor
   
Removing
–  Remove the supercharger air hoses -arrows-.
–  Remove the radiator → Chapter.
  Note
In order to avoid damage to the condenser or the pipes/hoses of the refrigerant, avoid pulling, bending or twisting excessively.
  WARNING
The air conditioning refrigerant circuit must not be opened.
  N10-10090
–  Unscrew bolts -arrows-. For this purpose, it is necessary to unhook the left and right air duct and pivot in the direction of the headlamp.
–  Tilt the upper edge of the intercooler slightly backward.
–  Unhook intercooler at bottom mounts. For this purpose, lift intercooler.
–  Move the intercooler in the direction of the engine.
–  Support the lower side of the intercooler to prevent it from falling.
  A19-10368
–  Remove bolts -arrows-.
–  Detach the charge air cooler upwards and remove from below.
Installing
Installation is carried out in the reverse sequence; note the following:
l  Tightening torques → Chapter
–  Installing hose connections with connector couplings → Chapter.
–  Fit the lock carrier, → Bodywork, exterior fitting work; Rep. gr.50.
–  Fill up coolant → Chapter.
  A19-10274

Supercharger air system tightness (engine codes BWJ, CDLA, CDLD) > < General diagram of the exhaust gas turbocharger supercharger air system (engine codes BWJ, CDLA, CDLD)