SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Remove and install the bottom cover of the timing chain >
< Removing and installing camshaft control valve?1N205
Leon Mk2
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Engine cylinder head, valve gear / Chain drive
Removing and installing timing chain cover (top)
Removing and installing timing chain cover (top)
Removing and installing timing chain cover (top)
Removing
→ Anchor
.
Installing
→ Anchor
.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Torque wrench 2 - 10 Nm -VAG 1783-, see equivalent
→ Anchor
Removing
–
Remove the purging line
-1-
, disengage the activated carbon vessel
-A-
and remove upwards
-B-
. Move the activated carbon vessel to one side.
–
Push coolant hoses to one side and secure with cable ties.
–
Detach the connector for valve 1 of the variable valve timing -N205-
-1-
–
Unscrew bolts
-arrows-
and remove camshaft control valve 1 -N205-.
–
Unscrew bolts
-1 to 5-
and remove timing chain cover (top).
Fitting
Installation is carried out in the reverse order, noting the following:
–
Oil the seal and the O-ring with engine oil.
–
Tighten the bolts
-1 to 5-
by hand in the sequence specified:
–
Tighten the bolts to a torque of 9 Nm using the torque wrench socket 2 - 10 Nm -VAG 1783- and the 10 mm socket -V.A.G 1783/1-.
–
Install camshaft control valve 1 -N205-
→ Chapter
.
l
Tightening torque
→ Chapter
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Engine cylinder head, valve gear / Chain drive
Removing and installing timing chain cover (top)
Remove and install the bottom cover of the timing chain >
< Removing and installing camshaft control valve?1N205