Leon Mk2
| Oil filter and oil cooler - exploded view |
| 1 - | Bracket for ancillary mechanical units |
| q | Removing and installing → Chapter. |
| 2 - | Oil pressure switch -F1- |
| q | 1.4 bar, black |
| q | check → Chapter |
| q | 20 Nm. |
| 3 - | Seal |
| q | Replace |
| 4 - | O ring |
| q | Replace |
| 5 - | O ring |
| q | Replace |
| 6 - | Lock pin |
| q | With spring |
| 7 - | Oil filter |
| q | 22 Nm. |
| q | Always replace within the specified time → Booklet101 |
| q | Remove and install with the oil filter spanner -3417-, see equivalent → Anchor |
| 8 - | Bolt. |
| q | 15 Nm. |
| 9 - | Thrust piece |
| 10 - | Seal |
| q | Replace |
| 11 - | Oil cooler |
| q | See note → Chapter |
| q | Ensure clearance from surrounding components |
| q | Coolant hose schematic diagram → Chapter. |
| q | Removing and installing → Chapter. |
| 12 - | Seal |
| q | Replace |
| 13 - | Bolt. |
| q | Tightening sequence → Fig. |
