Leon Mk2
| Fuel tank, vehicles with all-wheel drive - Installation survey |
| 1 - | Supply pipe |
| q | Black |
| q | Check for secure seating |
| q | Routing the lines → Fig. |
| 2 - | Return pipe |
| q | Blue colour |
| q | Check for secure seating |
| q | Routing the lines → Fig. |
| 3 - | Seal |
| q | Replace |
| q | When installing, fit dry in fuel tank opening. |
| q | Moisten with fuel only when installing flange |
| 4 - | Fuel delivery unit |
| q | Removing and installing → Chapter |
| q | If the fuel delivery unit has been replaced, the engine control unit must be adapted to the fuel pump → Vehicle diagnostic tester„Guided function“. |
| q | Checking fuel pump → Chapter. |
| q | Note fitting position on fuel tank → Fig. |
| q | With fuel level indicator sender -G- |
| q | Removing and installing fuel gauge sender -G- → Chapter. |
| q | Clean strainer if dirty |
| 5 - | Seal ring 110 Nm |
| q | Check for secure seating |
| q | Removing and installing with the rotation too -T10202- |
| 6 - | Filler cap set |
| q | With dustguard |
| q | Removing and installing → General body repairs, exterior; Rep. gr.55. |
| 7 - | Plug |
| q | Replace if damaged |
| 8 - | Securing bolt |
| q | tighten to 1.5 Nm. |
| 9 - | Earth connection |
| q | Check for secure seating |
| 10 - | 10 Nm |
| 11 - | Suction-jet pump |
| q | Clipped onto fuel gauge sender 2 -G169- |
| q | Removing and installing → Chapter |
| 12 - | Fuel gauge sender 2 -G169- |
| q | Removing and installing → Chapter |
| 13 - | Fuel tank |
| q | Removing and installing → Chapter |
| 14 - | tension belt |
| q | Note fitting position: |
| 15 - | 25 Nm |
| q | Replace |
| 16 - | Protective plate |
| q | Riveted with the exhaust system anchorage suspension |
| 17 - | Supply pipe |
| q | Leads to the fuel distributor |
| q | Check for secure seating. |
| 18 - | Fuel filter: |
| q | Arrow indicates direction of flow |
| q | Routing the lines → Fig. |
Note
|
|
|
|
