SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing coolant pump >
< Coolant pump: component overview
Leon Mk2
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Engine cooling / Removing and installing parts of cooling system
Poly V-belt pulley for coolant pump: removing and fitting
Poly V-belt pulley for coolant pump: removing and fitting
Poly V-belt pulley for coolant pump: removing and fitting
t
removing
→ Anchor
t
installing
→ Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
counterhold -T10172-, see equivalent
→ Anchor
removing
–
Remove poly V-belt
→ Chapter
.
–
Thread off the screws
-arrows-
and remove the bracket from the engine mounting.
–
Loosen the bolts for the poly V-belt pulley, for this purpose, counterhold using the counterhold tool -T10172-.
–
Remove bolt and take off poly V-belt pulley.
installing
Installation is carried out in the reverse order; note the following:
l
Tightening torques
→ Chapter
.
–
Install poly V-belt
→ Chapter
.
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Engine cooling / Removing and installing parts of cooling system
Poly V-belt pulley for coolant pump: removing and fitting
Removing and installing coolant pump >
< Coolant pump: component overview