SEAT Workshop Service and Repair Manuals

Upper bracket for auxiliary units: Removing and installing t  Removing → Anchor t  Installing → Anchor

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Hose clamp -3094-, see equivalent → Anchor

t	Collecting tray -VAS 6208-, see equivalent → Anchor

t	Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor

t  Torque wrench -VAG 1331-, see equivalent → Anchor. Removing –  Separate the under body protection. –  Remove the Poly V-belt → Chapter. –  Remove the alternator → Electrical system ; Rep. gr.27. –  Clamp off the coolant hoses -1- of the oil cooler with the hose clamps of up to 25 mm in diameter -3094-.

–  Open the spring-type hose using the pliers for spring type clips -VAS 6499- and remove the coolant hose. –  Remove the banjo bolt -2- and the securing screw -3-. –  Remove the oil feed tube,

–  Loosen fastening bolt -1- and remove the bracket.

Installing –  Fit the bracket for the ancillary units to the cylinder block. –  Tighten securing bolts -1- to 25 Nm. –  Fit the oil feed tube.

Tightening torques Fastening screws of the turbocharger: 8 Nm Banjo bolt: 20 Nm (replace seals) –  Connect the coolant hose -1- to the oil cooler and remove the hose clamp. –  Check the coolant level in the expansion tank and fill the coolant when necessary. –  Fit the alternator → Electrical system; Rep. gr.27. –  Poly-V belt: Installing → Chapter. Further assembly is basically the reverse of the dismantling sequence.