Leon Mk2
Catalytic converter and attachment parts - Assembly overview (Ibiza) |
1 - | Lambda probe -G39-, 50 Nm |
q | Only grease thread with „G 052 112 A3“. The „G 052 112 A3“ must not reach the probe body grooves |
q | Remove and install using the ring wrench set for lambda probes -3337- |
2 - | 23 Nm |
q | Renew |
q | Lubricate the studs of the exhaust manifold with high-temperature lubricant. |
3 - | Catalytic converter with exhaust pipe |
q | With vibration damper |
q | Do not bend decoupling element more than 10°. It may be damaged |
q | Removing and installing → Chapter |
4 - | Seal |
q | Renew |
5 - | Suspension |
6 - | Spring pin |
q | Mounting position and specified torque → Chapter |
q | Tighten bolted connections evenly. |
7 - | Suspension |
8 - | Seal |
q | Renew |
9 - | 18 Nm |
q | Observe tightening sequence → Chapter. |
q | Tightening torque of the studs in the cylinder head. 18 Nm (assemble using oil) |
10 - | 20 Nm |
11 - | Retainer |
12 - | Turbocharger |
q | With the charge pressure actuator -V465- |
q | Removing and installing → Chapter |
Note
The turbocharger can only be replaced completely with the exhaust manifold and the charge pressure actuator -V465-. |
13 - | Heat shield |
q | When assembling, first tighten the fastening bolts by hand |
14 - | 10 Nm |
q | When assembling, first tighten the fastening bolts by hand |
15 - | Heat shield |
q | When assembling, first tighten the fastening bolts by hand |
16 - | 10 Nm |
q | When assembling, first tighten the fastening bolts by hand |
17 - | 10 Nm |
q | When assembling, first tighten the fastening bolts by hand |
18 - | Lambda probes after the catalytic converter -G130- |
q | Tightening torque: 50 Nm |
q | Only grease thread with „G 052 112 A3“. The „G 052 112 A3“ must not reach the probe body grooves |
q | In case of leakage, cut out and replace sealing ring |
19 - | 10 Nm |
q | When assembling, first tighten the fastening bolts by hand |
20 - | 25 Nm |