Leon Mk2
Note
|
| 1 - | Locating bolt |
| q | Removing and installing crankshaft pulley → Chapter. |
| q | Replace |
| q | Contact surface for securing bolt must be free of oil and grease. |
| q | Oil threads before inserting. |
| q | Secure the pulley with the counterhold -3415- and counterhold -3415/1- to prevent it from turning |
| 2 - | Pulley |
| q | removing and fitting → Chapter |
| q | Contact surfaces must be free of oil and grease. |
| q | During assembly and removal, secure using the tool -3415- and the counterhold -3415/1- to prevent it from turning. |
| q | Poly-V belt: removing and installing → Chapter |
| 3 - | Oil seal |
| q | replace → Chapter |
| 4 - | Bush |
| q | Contact surfaces must be free of oil and grease. |
| 5 - | O ring |
| q | Replace |
| 6 - | aluminium cylinder block! |
| 7 - | 60 Nm + further 1/4 (90 °) |
| 8 - | Flywheel/drive plate |
| q | When removing and installing flywheel, lock with counterhold -T10044-. |
| 9 - | Intermediate plate |
| q | Must sit on dowel sleeves |
| q | Do not damage or bend when assembling. |
| 10 - | 12 Nm |
| q | Replace |
| 11 - | Sealing flange with sender wheel and oil seal |
| q | With engine speed sender -G28- (not illustrated). |
| q | Engine speed sender -G28- removing and installing → Chapter |
| q | Tightening torque of the engine speed sender -G28-: 5 Nm |
| q | Renew sealing flange complete with oil seal and sender wheel only. |
| q | Renewing crankshaft sealing flange - flywheel end → Chapter. |
