seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust turbocharger - Assembly overview > < Checking fuel tank breather

Leon Mk2

Turbocharger
Turbocharger
  Note
t  Secure all hose connections with hose clips which conform to production standard.
t  Hose connections and hoses for charge air system must be free from oil and grease before fitting. Only in the case of plug-in couplings, the sealing ring and sealing surface must be oiled slightly → Chapter.
t  Charge air system must be free of leaks.
t  Renew self-locking nuts.
   
t  Hose clip pliers -VAS 6340- are recommended for fitting spring-type hose clips.
t  Fill turbocharger with engine oil at oil supply line connection.
t  After installing turbocharger, run engine for about 1 minute at idle and do not rev up immediately. This ensures that the turbocharger is fully primed with oil.
→ Chapter „Exhaust turbocharger - Assembly overview“
→ Chapter „Part I:“
→ Chapter „Part II:“
→ Chapter „Removing and installing turbocharger“
→ Chapter „Checking vacuum unit for turbocharger“
→ Chapter „Turbocharger pressure capsule: Removing and installing.“
→ Chapter „Adjusting vacuum unit for turbocharger“
  W00-10380

Exhaust turbocharger - Assembly overview > < Checking fuel tank breather