Leon Mk2
| Part II |
| 1 - | Tension roller |
| 2 - | 25 Nm |
| 3 - | Tensioning rod |
| 4 - | Dust protection cover |
| 5 - | 10 Nm |
| 6 - | Toothed belt guard-lower part |
| 7 - | Toothed belt guard-upper part |
| 8 - | 45 Nm |
| 9 - | Tension roller |
| 10 - | Toothed belt |
| q | Before removing this, mark the direction of rotation |
| q | Check for wear |
| q | Do not kink |
| q | removing and fitting, tensioning → Chapter |
| 11 - | Toothed belt guard |
| 12 - | Toothed belt guard-rear part |
| 13 - | Intermediate axle cogwheel |
| 14 - | 80 Nm |
| q | Use the locking tool -T20018A- to loosen and tighten |
| 15 - | Toothed belt wheel-crankshaft |
| q | Note the position when fitting the toothed belt → Chapter |
| 16 - | 90 Nm + 1/4 turn (90°) |
| q | Replacement |
| q | Use the locking tool -T20018A- to loosen and tighten |
| q | Lubricate the thread and the collar |
| q | Tightening can be done in several stages |
| q | The retightening angle may be measured using the angle measurement tool -T20030- |
| 17 - | Pulley |
| q | For coolant pump |
| q | Poly-V belt version |
| q | Note the position when fitting |
| q | Removing the Poly-V belt → Chapter |
| 18 - | Ribbed belt |
| q | Before removing this, mark the rotation direction |
| q | Check for wear |
| q | Do not kink |
| q | Removing and fitting → Chapter |
| 19 - | Belt pulley/vibration damper |
| q | Fitting is only possible in one position, -the holes are distributed asymmetrically- |
| q | Note the position when fitting the toothed belt → Chapter |
| 20 - | Trapezoidal drive belt |
| q | Adjustment of the trapezoidal drive belt tension → Rep. Gr.48 |
| 21 - | Pulley |
| q | For coolant pump |
| q | Version for trapezoidal drive belt |
| 22 - | Pulley |
