Leon Mk2
Note
|
| 1 - | Securing bolt |
| q | Removing and installing crankshaft pulley → Chapter. |
| q | Replace |
| q | Contact surface for securing bolt must be free of oil and grease. |
| q | Oil threads before inserting. |
| q | Secure pulley against turning with counterhold -3415-. |
| q | The turning further angle can be measured with a commercial protractor. |
| 2 - | Pulley |
| q | With diamond coated washer |
| q | Contact surfaces must be free of oil and grease. |
| q | Secure against turning with counterhold -3415- when removing and installing |
| q | Removing poly V-belt → Chapter |
| 3 - | Seal |
| q | Replace |
| 4 - | Bush |
| q | Contact surfaces must be free of oil and grease. |
| 5 - | O ring |
| q | Replace |
| 6 - | cylinder block |
| q | Removing and installing → Chapter. |
| 7 - | 60 Nm +1/4 turn further (90º) |
| 8 - | Flywheel/drive plate |
| q | When removing and installing flywheel, lock with counterhold -T10044-. |
| 9 - | Intermediate plate |
| q | Must sit on dowel sleeves |
| q | Do not damage when assembling. |
| 10 - | 12 Nm |
| q | Replace |
| 11 - | Sealing flange with sender wheel and oil seal |
| q | Removing and installing engine speed sender -G28- (not shown) → Chapter. |
| q | Tightening torque for the engine speed sender -G28-: 5 Nm |
| q | Renew sealing flange complete with oil seal and sender wheel only. |
| q | Renewing crankshaft sealing flange - flywheel end → Chapter. |
