seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cooling > < Oil pump: removing and installing

Leon Mk2

Oil pressure and oil pressure switch: checking
   
Oil pressure and oil pressure switch: checking
Special tools and workshop equipment required
t  Oil pressure tester -V.A.G 1342-
t  Pressure tester -V.A.G 1527B-
t  Auxiliary cable kit -V.A.G 1594C-

  Note
Checking operation of and servicing visual and acoustic oil pressure gauge → Current flow diagrams, Electrical fault finding and Fitting locations
   
Checking sequence
–  Remove the oil pressure switch -F1-, and screw it into the tester.
–  Screw tester into cylinder head in place of oil pressure switch.
–  Connect brown wire of tester to earth (-).
–  Connect voltage tester -V.A.G 1527B- to battery positive (+) and oil pressure switch using cables from auxiliary measuring set -V.A.G 1594C-.
–  If the LED lights up, replace oil pressure switch -F1-.
If LED does not light up:
–  Start engine and increase speed slowly. At 0.3…0.7 bar the LED must light up, otherwise renew oil pressure switch.
–  Increase engine speed further. At 2000 rpm and an oil temperature of 80 °C the oil pressure should be at least 2.0 bar.
At higher engine speeds, the oil pressure must not exceed 7.0 bar.
  V17-0540

Engine cooling > < Oil pump: removing and installing