SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing fuel tank >
< Removing and installing external fuel gauge senderG with two cable connections
Leon Mk2
Power unit
4 cylinder Injection engine (1.6 l engine, BiFuel)
Fuel supply, gas operation / Parts of fuel supply system
Removing and installing interior fuel gauge senderG
Removing and installing interior fuel gauge senderG
Removing and installing interior fuel gauge sender -G-
Removal:
–
Remove fuel delivery unit
→ Chapter
.
–
Pull fuel gauge sender -G- slightly to side and upwards at the same time.
–
If the sender cannot be released in this way, push the securing tabs
-arrows-
to the side slightly.
–
Note colour assignment of cables for re-installation.
–
Release and unplug connectors
-1-
to
-3-
and bend back locking hooks of connectors.
Installation
Installation is in the reverse sequence of removal. Note the following:
–
Insert connector
-1...3-
. Note the colour identification.
–
Check connectors are secured properly by pulling.
–
Insert fuel gauge sender -G- into guide on fuel delivery unit and press down until it engages.
–
Install fuel delivery unit
→ Chapter
.
Tightening torque
Component
Tightening torque
Union nut
80 Nm
Power unit
4 cylinder Injection engine (1.6 l engine, BiFuel)
Fuel supply, gas operation / Parts of fuel supply system
Removing and installing interior fuel gauge senderG
Removing and installing fuel tank >
< Removing and installing external fuel gauge senderG with two cable connections