Leon Mk2
| Engine block, List of components |
| 1 - | Knock sensor I -G61- |
| q | Gold plated contacts |
| 2 - | 20 Nm |
| q | Tightening torque influences functions of knock sensor |
| 3 - | Oil dipstick |
| q | The oil level must not be above the MAX mark. - Risk of damage to the catalytic converter! |
| q | Dip stick marks → Fig. |
| 4 - | Retainer |
| q | for ignition transformer -N152- |
| 5 - | 10 Nm |
| 6 - | 10 Nm |
| 7 - | 10 Nm |
| 8 - | Retainer |
| 9 - | 6 Nm |
| 10 - | Oil filter bracket |
| q | Engine code BGU → Chapter |
| q | Engine code BSE, BSF, CCSA, CMXA → Chapter |
| 11 - | 15 Nm + 1/4 turn (90°) further |
| 12 - | Seal |
| q | Renew |
| 13 - | 10 Nm |
| 14 - | Engine speed sender -G28- |
| 15 - | Pipe for coolant |
| 16 - | 15 Nm |
| 17 - | O ring |
| q | Renew |
| 18 - | Seal |
| q | Renew |
| 19 - | Coolant thermostat: |
| q | Removing and fitting → Chapter |
| q | Check: Heat the thermostat in water |
| q | Starts opening at approx. 85 ℃ |
| q | Fully open at approx. 105 ℃ |
| q | Opening stroke approx. 7 mm |
| 20 - | cylinder block |
| q | Sealing flanges and flywheel/drive wheel - Components overview → Chapter |
| q | Crankshaft - Components overview → Chapter |
| q | Piston and conrod - Components overview → Chapter |
| 21 - | Coolant tube seal |
| q | Renew |
