Note t
| When installing an exchange cylinder head, all the contact surfaces between the support elements, roller rocker fingers and cams must be oiled before installing the camshaft housing. |
t
| The plastic protectors fitted to protect the open valves must only be removed immediately before fitting the cylinder head. |
t
| If the cylinder head is replaced, all the coolant in the system must also be changed. |
t
| Oil the support and slide surfaces before carrying out assembly work. |
t
| Remove and install intake manifold → Chapter. |
Distribution chain and oil pump drive chain: Removing and installing radio → Chapter |
Removing and fitting the camshaft housing → Chapter |
Cylinder head: Removing and installing radio → Chapter |
|
|
|