Leon Mk2
Part I Timing belt system - Assembly overview |
1 - | 20 Nm |
2 - | Belt pulley |
q | For the coolant pump |
q | To loosen and tighten, use the water pump wrench -V.A.G 1590- |
3 - | 20 Nm +1/4 turn further (90º) |
4 - | 40 Nm |
5 - | Washer |
6 - | Idle wheel |
7 - | Washer |
8 - | Spacing sleeve |
9 - | Alternator |
10 - | 25 Nm |
11 - | Spacing sleeve |
12 - | Tensioning element |
13 - | Belt pulley |
q | For crankshaft |
q | The contact surfaces must be free of oil and grease. |
14 - | Attachment bolt |
q | Follow the correct tightening order → Chapter |
q | Replace |
q | The contact surface of the fastening bolt must be free of oil and grease |
q | Apply oil before fitting it (thread) |
q | Secure the pulley with the counterhold -3415- to prevent it from turning |
q | The retightening can be done in steps |
q | The torque angle can be measured with a Hazet 6690 torque or equivalent |