SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder Injection engine (2.0l, 4V Direct injection, turbocharger and chain control) | Engine lubrication | Sump and oil pump | Removing and installing coarse oil separator

Removing and installing coarse oil separator

Removing:

–	Remove the sound insulation → Bodywork, exterior installation work; Rep. gr.50

–	Remove bolts -1 … 9- and detach coarse oil separator.

Caution

Protect lubrication system against contamination.

Seal off opening with clean cloth.

Installing:

Note

t	Renew gaskets and seals.

t	Secure all hose connections with the correct type of hose clips (same as original equipment) → ETKA (electronic parts catalogue).

Installation is carried out in the reverse order; note the following:

–	Tighten bolts to 9 Nm in sequence -1 ... 9-.

SEAT Workshop Service and Repair Manuals