Leon Mk2
Assembly overview - sealing flange on gearbox side and flywheel |
1 - | cylinder block |
q | Removing and installing crankshaft → Chapter. |
q | Piston and rod: disassembly and assembly → Chapter |
2 - | Locking pin |
q | Not fitted |
3 - | Sealing flange on gearbox side |
q | With seal |
q | Always replace completely |
q | Removing and installing → Chapter. |
4 - | Bolt |
q | Tightening sequence → Fig. |
5 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage or bend when assembling. |
q | Is fitted onto sealing flange → Fig. |
6 - | Bolt |
q | For flywheel |
q | 60 Nm + 90° (1/4) turn further |
q | replace |
7 - | Flywheel |
q | Removing and installing flywheel → Chapter |
q | Can only be installed in one position, holes are offset. |
8 - | Locking pin |
q | Not fitted |
|
|