seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing the theft secured engine control unit > < Engine control unitJ623

Leon Mk2

Removing and installing engine control unit
Removing and installing engine control unit
  Note
Removing and installing anti-theft engine control unit → Chapter.
–  To replace the engine control unit, connect the → Vehicle diagnostic, testing and information system VAS 5051 and initiate the guided function „Replacing control unit“.
Removing:
–  Switch ignition OFF.
–  Remove windscreen wiper arms → Electrical system; Rep. gr.92.
–  Remove plenum chamber cover → General body repairs, exterior; Rep. gr.64.
–  Remove plenum chamber bulkhead → Bodywork, exterior fitting work; Rep. gr.50.
   
–  Raise engine control unit -1- in front area in -direction of arrow-.
–  Pull engine control unit forwards out of the side guides -2-.
  N24-10675
–  Slide connector locking devices -1- on engine control unit in -direction of arrow- and pull off both connectors.
Installing:
Tightening torque of securing nuts for retaining frame: 6 Nm
–  Attach connectors to engine control unit and slide locking devices inwards until they engage.
  N24-10676
–  Push engine control unit -1- into side guides -2- in the -direction of arrow-.
–  Install plenum chamber bulkhead → Bodywork, exterior fitting work; Rep. gr.50.
–  Install plenum chamber cover → Bodywork, exterior fitting work; Rep. gr.64.
–  Install windscreen wiper arms → Electrical system; Rep. gr.92.
  N24-10675

Removing and installing the theft secured engine control unit > < Engine control unitJ623