Leon Mk2
Valve gear - assembly overview |
1 - | 100 Nm |
q | Use counterhold -3415- to loosen and tighten |
2 - | Camshaft wheels |
3 - | Seal |
q | Replace → Chapter |
4 - | Woodruff key |
5 - | 23 Nm |
6 - | Ladder-type frame |
q | The seal surface cannot be reworked |
q | With integrated camshaft bearings |
q | Bearing 1 on the pulley |
q | Note the tightening order for the camshaft bearing sockets → Chapter |
q | Carefully apply the sealant D 188 800 A1 in the sealant groove and the bottom sealing surface |
7 - | Camshaft: |
q | check the axial play → Chapter |
q | Removing and installing → Chapter |
q | Check radial clearance with Plastigage; Wear limit: 0.1 mm |
q | out-of-true: Max. 0.04 mm |
8 - | Roller rocker arms |
q | Do not interchange |
q | Check roller bearing |
q | Oil contact surface. |
q | ?When installing, secure to support element using securing clip. |
9 - | Supporting element |
q | Do not interchange |
q | With hydraulic valve play compensation |
q | Oil contact surface. |
q | Checking → Chapter |
10 - | Woodruff keys |
11 - | Valve plate spring |
12 - | Valve spring |
q | Remove and install with cylinder head removed using valve spring compressor -2037- |
q | Cylinder head fitted → Chapter |
13 - | Valve stem seal |
q | Replace → Chapter |
14 - | Valve guide |
q | Checking → Chapter |
15 - | Sealing plug |
q | Must fit precisely |
q | For removal, pierce the only the centre of the rubber using a screwdriver and lever |
16 - | Cylinder head |
q | The sealing surface on the camshaft side may not be reworked |
q | Reworking valve seats → Chapter. |
17 - | Valves: |
q | Not to be reworked, only grinding in is permissible |
q | Valve dimensions → Chapter |
|