Leon Mk2
| Part II Oil filter holder - Assembly overview |
| 1 - | Screw plug, 15 Nm |
| 2 - | Seal |
| q | In case of leakage, cut out and replace sealing ring |
| 3 - | Oil pressure switch -F1-, 1.4 Nm |
| q | 25 Nm |
| q | Black |
| q | Checking → Chapter |
| 4 - | Seal |
| q | In case of leakage, cut out and replace sealing ring |
| 5 - | Oil filter bracket |
| q | With integrated non-return valve |
| 6 - | 15 Nm + 90° |
| q | Renew |
| 7 - | Oil filter |
| q | Loosen using a spring-type clip or the oil filter spanner -3417- |
| q | Tighten by hand |
| q | Observe the installation instructions printed on the filter |
| 8 - | Screw plug, 40 Nm |
| q | Renew |
| 9 - | Seal |
| q | cannot be lost rolled onto → Item |
| 10 - | Spring |
| q | For pressure relief valve, approx. 4 bar |
| 11 - | Piston |
| q | For pressure relief valve, approx. 4 bar |
| 12 - | Seal |
| q | Renew |
| 13 - | Oil non-return valve |
| q | Integrated in the oil filter support |
| q | Not available as a separate replacement part |
| 14 - | O ring |