Leon Mk2
| Part III: |
| 1 - | Knock sensor 1 -G61- |
| q | Gold plated contacts |
| 2 - | 20 Nm |
| q | Tightening torque influences functions of knock sensor |
| 3 - | Oil dipstick |
| q | Oil level must not be above max. mark on dipstick! |
| q | Marks → Fig. |
| 4 - | Support |
| q | for ignition transformer |
| 5 - | 10 Nm |
| 6 - | 10 Nm |
| 7 - | 10 Nm |
| 8 - | Support |
| 9 - | 6 Nm |
| 10 - | Oil filter bracket with accessories |
| q | Oil filter bracket - Assembly overview → Chapter |
| 11 - | 15 Nm + turn 90° further |
| 12 - | Seal |
| q | replace |
| 13 - | 10 Nm |
| 14 - | Engine speed sender -G28- |
| 15 - | Joint mouth |
| 16 - | 15 Nm |
| 17 - | O ring |
| q | replace |
| 18 - | Oil seal |
| q | replace |
| 19 - | Coolant thermostat: |
| q | removing and fitting → Chapter |
| q | Check: heat the thermostat in water |
| q | Starts opening at approx. 85 ℃ |
| q | Fully open at approx. 105 ℃ |
| q | Opening lift at least 7 mm. |
| 20 - | cylinder block |
| q | Removing and installing sealing flange and flywheel → Chapter. |
| q | Removing and installing crankshaft → Chapter. |
| q | Piston and rod: disassembly and assembly → Chapter |
| 21 - | Seal on the coolant pipe |
| q | replace |
