seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine: Disassembling and assembling > < Timing belt guard - upper part: removing

Leon Mk2

Removing and installing Poly-V belt
Removing and installing Poly-V belt
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Pin -T10060A-
Removal:
–  Remove the sound-proofing → Body, exterior assembly work; Rep. gr.50.
–  Mark direction of rotation of poly V-belt.
  W00-10235
–  Swing tensioning element in direction of arrow to relieve tension on poly V-belt.
  A13-0083
–  Lock the tensioning device with the pin -T10060 A-.
–  Remove poly V-belt.
Installing
Fit the poly V-belt in the reverse order, paying attention to the following:
t  When fitting poly V-belt, check direction of belt rotation and proper seating of belt in belt pulleys.
t  On vehicles with no air conditioner, fit ribbed belt at alternator as last step.
t  For vehicles with air conditioning, put Poly-V belt over air conditioning compressor last.
After completing the work, always start the engine and check that the belt rotates correctly.
  N13-10135
Belt routing without air conditioning compressor
  N13-0755
Belt routing with air conditioning
  N13-0754

Engine: Disassembling and assembling > < Timing belt guard - upper part: removing