Leon Mk2
| Part IV |
Note!| For repairs to the clutch: → Rep. Gr.30. |
| 1 - | 90 Nm + 1/4 turn (90°) further |
| q | Replacement |
| q | Use tool -T20018A- to loosen and tighten |
| q | Threads and shoulder must be free of oil and grease |
| 2 - | Timing belt cogwheel, crankshaft |
| q | There must be no oil on the contact surface between the toothed belt and the crankshaft |
| 3 - | 15 Nm |
| 4 - | Oil seal |
| q | Replace → Chapter |
| q | Do not oil |
| 5 - | Crankshaft oil seal |
| q | Removing and fitting → Chapter |
| q | Assemble with silicone sealant -D 176 404 A2- → Chapter |
| 6 - | Cylinder block |
| q | Crankshaft: removing and fitting → Chapter |
| q | Piston and piston rod: disassembly and assembly → Chapter |
| 7 - | 60 Nm + 1/4 turn (90°) |
| q | Replacement |
| q | Use tool -T20075A- to loosen and tighten |
| 8 - | Engine flywheel |
| q | Removing and fitting → Chapter |
| 9 - | Intermediate plate |
| q | Do not damage/bend when assembling |
| q | Installation position → Fig. |
| 10 - | Crank shaft oil seal with seal |
| q | Always replace completely |
| q | Do not oil |
| q | Ensure absolutely that the seal lip is not damaged or bent during fitting |
| q | To fit, insert the guide sleeve (supplied with the seal) on the crankshaft |
| q | For removal and fitting, the oil sump needs to be removed → Chapter |
|
|
