seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Dual mass flywheel / drive plate: Removing and installing > < Removing and fitting the aluminium seal

Leon Mk2

Removing and fitting the sheet plate seal
Removing and fitting the sheet plate seal
Special tools and workshop equipment required
   
t  Guide sleeve -T20097-
Seal: removing
–  Remove gearbox → Rep. gr.34.
–  Remove the flywheel or drive plate.
–  Remove sump → Chapter.
  W00-2379
–  Remove sealing flange -arrows- .
Fit the sealing flange
Sheet plate seal specifications:
t  Different centring pins are not used
t  Sealing profile faces the gearbox
t  The screws are shorter than with an aluminium sealing ring
  Note
t  Do not grease or oil the seal lip of the seal
t  When a sheet plate flange should be mounted instead of an aluminium sealing ring, the centring pins must be removed and shorter screws must be used → ETKA (electronic parts catalogue).
–  Clean sealing surfaces. They must be free of oil and grease.
–  Remove oil residue from crankshaft journal using clean cloth.
  N13-10128
–  Place the guide bush -T20097- on the crankshaft journal.
–  Push the seal over the guide sleeve -T20097- onto the crankshaft journal.
  N13-10333
–  Tighten the attachment bolts to 15 Nm -arrows-.
–  Fit the oil sump → Chapter.
Further assembly is basically the reverse of the dismantling sequence.
  N13-10128

Dual mass flywheel / drive plate: Removing and installing > < Removing and fitting the aluminium seal