SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing sealing flanges and flywheel or drive plate >
< Removing and installing dual-mass flywheel
Leon Mk2
Power unit
4 cylinder Petrol direct injection engine, Mechanics
Enginecrankshaft group, pistons
Sealing flange and flywheel / drive plate: removing and fitting / al_mass_flywheel/drive_plate_removing_and_installing/">Dual mass flywheel / drive plate: Removing and installing
Removing and positioning the flywheel
Removing and positioning the flywheel
Removing and positioning the flywheel
t
Removing
→ Anchor
t
Installing
→ Anchor
Special tools and workshop equipment required
t
Counterhold tool -T20064-
t
Depth gauge
Removing
–
Attach the counterhold -T20064- to the drive plate.
–
Loosen the bolts holding the drive plate.
Installing
–
Fit the drive plate using the washer with recesses
-1-
.
–
Insert new bolts
-3-
and tighten to a torque of 30 Nm.
–
Check dimension
-a-
in 3 points and calculate the average.
t
Specification: 19.5 ... 21.1 mm
Note
The measurement is made through the hole of the drive plate to the bored surface of the cylinder block.
If the specification is not attained:
–
Remove the drive plate again and use the compensation washer
-2-
. Tighten the bolts again
-3-
to a torque of 30 Nm.
Power unit
4 cylinder Petrol direct injection engine, Mechanics
Enginecrankshaft group, pistons
Sealing flange and flywheel / drive plate: removing and fitting / al_mass_flywheel/drive_plate_removing_and_installing/">Dual mass flywheel / drive plate: Removing and installing
Removing and positioning the flywheel
Removing and installing sealing flanges and flywheel or drive plate >
< Removing and installing dual-mass flywheel